Thank you for visiting our website.
This site is exclusively reserved for health professionals.
I am a health professional
I want to access the \“patient\” website
Multiple Screw-Retained Prosthesis
Conical abutments are recommended for screw-retained bridges and bar-supported prostheses.
They are available with angulations of 0°, 17°, and 30°, and come in a wide range of gingival heights.
Conical abutments allow, if necessary, the removal of prostheses during maintenance phases while preserving the integrity of the soft tissue seal.
Angled abutments are offered in both rotational and anti-rotational versions to accommodate direct or indirect techniques.
The abutment can be placed after removal of the healing screw.
Impressions are taken directly on the abutment using impression transfers designed for straight conical abutments.
A protective cover cap is used to shield the abutment during the fabrication of the final prosthesis by the dental technician.
If needed, 6 mm or 8 mm height caps are available to support the soft tissues until the provisional prosthesis is delivered.
Secondary components for 0° straight conical abutments (analogs, transfers, cover caps, sleeves, bases) are identical to those available in the In-Kone® ST range.
Angled conical abutments are indicated to correct implant axis discrepancies in multiple-unit prostheses.
They are available in both indexed and non-indexed versions.
It is recommended to make impressions directly on the abutment using impression transfers for angled conical abutments.
A protective cover cap is available to protect the abutment during the fabrication phase of the final prosthesis by the technician.
Secondary components for angled conical abutments (analogs, transfers, cover caps, sleeves, bases) are identical to those available in the In-Kone® ST range.
In-Kone® WD Bases & pre-milled
In-Kone® WD Abutments
In-Kone® WD Transfers & Analogs
In-Kone® WD Healing & Cover screws